BuckBucker Clamp - Bench-Mounted Humbucker Soldering Jig M50 You may need to replace

You may need to replace your belts with longer ones

IT SHOWS HOW THE FOOT OF YOUR LASER WILL SIT IN THE BRICK SLOTS

If you have shop air that is recommend between 20-25psi

Comgrow 10w Dual Diode LD+FAC=48W

- The 110L/min pump is for dual or multi-laser setups

BuckBucker Clamp - Bench-Mounted Humbucker Soldering Jig M50 You may need to replaceThe BuckBucker Clamp is a purpose built soldering jig designed to securely hold humbucker pickups during wiring and repair work. It creates a stable, repeatable setup that keeps your pickup in place while freeing up both hands for clean solder joints. Important: This jig must be mounted to at least a board (board not included). If used without a backer, the base can flex and the jig may not work as intended. The BuckBucker Clamp uses a four toggle